Docker TIG stack

Based on the telegraf influxdb grafana office images:

• telegraf
• influxdb
• grafana

Requirements

Setup

Usage

Start the ELK stack using docker-compose:

$ docker-compose up

You can also choose to run it in background (detached mode):

$ docker-compose up -d

By default, the stack exposes the following ports:

• 3000: grafana for users.
• 8083: influxdb for webui
• 8086: influxdb for telegraf interface

WARNING: If you're using boot2docker, you must access it via the boot2docker IP address instead of localhost.

WARNING: If you're using Docker Toolbox, you must access it via the docker-machine IP address instead of localhost.

Configuration

NOTE: Configuration is not dynamically reloaded, you will need to restart the stack after any change in the configuration of a component.

How can I tune telegraf configuration?

The telegraf default configuration is stored in telegraf/config/telegraf.conf.

How can I tune influxdb configuration?

The influxdb configuration is stored in influxdb/config/influxdb.conf.