Diskplorer is a small set of tools around fio that can be used to discover disk read latency at different read and write workloads. Diskplorer runs a matrix of 21 write workloads (0% to 100% of the maximum bandwidth, in 5% increments) and 21 read workloads (0% to 100% of the maximum IOPS, in 5% increments) for a total of 441 different workloads. The disk is fully written first in order to eliminate clean-disk effects.
Diskplorer runs in two steps: step 1 generates a json result file, and must be run on the system being tested, and step 2 generates latency charts from the result file.
Caution: the test is destructive. Do not use on disks that have real data.
Install the dependencies with
sudo dnf install -y fio
or
apt-get install -y fio
Obtain the maximum write bandwith and maximum read IOPS from the device data sheet.
Run diskplorer (substitute N1, N2, and /dev/name with your device parameters):
sudo ./diskplorer.py --max-read-iops N1 --max-write-iops N2 /dev/name --result-file your-results.json
It is recommended to save the fio test file for later reference (`--fio-job-directory')
sudo is required due to direct disk access.
This will run for several hours. Some smoke may be emitted from the disk.
Once done, copy the result file (test.json) to your workstation and view the charts with
./latency-postprocess.py test.json
With 4k blocksize, showing reduction in IOPS due to increased bandwidth demand:
With 16k blocksize, showing further reduction in IOPS due to increased bandwidth demand:
These results are using aio instead of io_uring due to bad interaction between md and io_uring.
Please see the old README page