TKB Home

This app adds support for TKB Home devices in Homey.

Supported devices:

• TSM02 - 4-in-1 Multi Sensor
• TSP01 - 3-in-1 Multi Sensor
• TZ35 - Single & Dual Wall Dimmer
• TZ36 - Single & Dual Wall Switch
• TZ55 - Single & Dual Wall Dimmer
• TZ56 - Single & Dual Wall Switch
• TZ65 - Single & Dual Wall Dimmer
• TZ66 - Single & Dual Wall Switch
• TZ67 - Wallplug Dimmer (all types)
• TZ67-PLUS - Wallplug Dimmer (Z-Wave Plus) (all types)
• TZ68 - Wallplug Switch (all types)
• TZ68-PLUS - Wallplug Switch (Z-Wave Plus) (all types)

Supported Languages:

• English
• Dutch (Nederlands)

Notes:

TZ35/TZ55/TZ65 The Wall Dimmers need to be polled to get the correct dim state when you dim it with the switch itself.
The interval is by default on 300 seconds (5 minutes).
It is not recommended to put this below 60 seconds (1 minute), it might cause too much traffic.
You can also "immediately" update its state in homey, by just pressing any of the switches once.
The dim level takes about 2.5 seconds to update when switching on, since the dimmer dims up to its set brightness.

TZ67(-PLUS)/TZ68(-PLUS) The wallplugs only use the polling interval if you use the button on the wallplug itself.
It is not recommended to put this below 60 seconds (1 minute), it might cause too much traffic.

Change Log:

1.0.4: Some small bug fixes.

1.0.3: Fix:
All wall switches/dimmers: the right switch should work again
Do make sure homey's ID (1) is in association groups 2 and 3 only, not in 1 and 4
Update:
All switch icons.
Multi sensor icons.
Z-wave driver to 1.1.8.

1.0.2: Fix:
TZ36 - ID's were incorrect
TZ56 - ID's were incorrect
"set dim level" flow cards, now work properly

1.0.1: Added support:

• TSM02 - 4-in-1 Multi Sensor

• TSP01 - 3-in-1 Multi Sensor
• TZ35 - Single & Dual Wall Dimmer
• TZ36 - Single & Dual Wall Switch
• TZ55 - Single & Dual Wall Dimmer
• TZ56 - Single & Dual Wall Switch
• TZ67-PLUS Wallplug Dimmer (Z-Wave Plus)
  Updated Association Group Hints
  Updated Z-wave driver (1.1.2)

1.0.0: Update Z-Wave driver (1.1.0)
Fixed TZ65D right button flow triggers
Add support TZ66 (Single & Dual)
Add support TZ68-PLUS (all types)
Add Polling for TZ67 and TZ68 (needed if people use the hardware button.)

0.9.4: Fixed TZ67 & TZ68 their HardWare state change report

0.9.3: Fixed TZ68 not using the right Command Class
Fixed flow cards TZ65

0.9.2: Fixed a bug in flow triggers TZ65(D)
Fixed a bug that TZ67 & TZ68 state in homey did not change on physical changes

0.9.1: Changed TZ65D to TZ65 (TZ65S & TZ65D are both same driver)

0.9.0: First Addition to app-store.

Donate:

If you like the work that I have done, and loved the magic.
Maybe you can think about filling my magic meter again: