MIOB, the Mobile IO Box is a flexible unit for interconnecting laboratory equipment and measurements.
Built around a Xilinx Ultrascale+ VC106 FPGA evaluation board, it provides both computation power and IO flexibility for various interfacing tasks in a laboratory.
This repository contains the construction drawings, bill of materials, software and general documentation for building your own MIOB.
#Set pin as output
raspi-gpio set 24 op
#Turn off FPGA Power
raspi-gpio set 24 dh
#Turn on FPGA Power
raspi-gpio set 24 dl
sudo picocom --baud 115200 --flow n /dev/ttyUSB0
- Niklas Eiling (@n-eiling), Institute for Automation of Complex Power Systems, RWTH Aachen University)
- Steffen Vogel (@stv0g, Institute for Automation of Complex Power Systems, RWTH Aachen University)
The contents of this repository are licensed under the weakly-reciprocal version of the CERN Open Hardware Licence Version 2
The development of MIOB has been supported by the following projects:
- ERIGrid 2.0 project of the H2020 Programme under Grant Agreement No. 870620
- Urban Energy Lab 4.0 sub-project InFIS.