Documentation PR (#20)

Added some CAN info Added print orientation picture
DraftShift · Feb 27, 2024 · ac350e7 · ac350e7
1 parent 43c0e38
commit ac350e7
Show file tree

Hide file tree

Showing 3 changed files with 5 additions and 0 deletions.
diff --git a/README.md b/README.md
@@ -19,6 +19,9 @@ All parts (screws, magnets, etc) are Voron, and Voron Tap standards.
 
 Print orientation is flat on the parts back with supports enabled currently, we are working on models with integrated supports.
 
+![Print Orientation](media/Print_orientation.jpg?raw=true)
+
+
 **NOTE: Currently pins may feel very loose, this is by design to allow for room for glue or epoxy (recommended) to set.  Normally press fit is good enough for testined, but for actual use make sure to secure the pins properly.**
 
 **NOTE: D2HW shuttle is not compatible with Hall Effects, and D2HW back plate will affect cooling.**

diff --git a/media/Print_orientation.jpg b/media/Print_orientation.jpg
diff --git a/wiki/Home.md b/wiki/Home.md
@@ -15,3 +15,5 @@
 4. If you run homing on Z or QGL and you are getting lots of restarts or excessive runs.  Make sure you are using **N52** magnets, and check that your umbilicals are properly support and the right length.  If these 3 things aren't checked it will affect the tap precision.
 
 5. A lot of people are asking which toolhead/extruder is recommended. The answer is whatever you want. The changer and tools are completely separate. That being said, using something that is already a tested combination for Stealth Burner or Dragon Burner is going to be the easiest.
+
+6. CAN setup. You are definitely going to want to use CAN to connect your toolheads. Its only 4 wires and much lighter. You don't need anything fancy to split out the signal. Simple WAGO connectors work just fine. Of course, there are options for boards that will split the signal as well if you want something that looks a little more professional. Run wires up to the umbilical from your controller and power supply, then use WAGO's there to split the signal. See the guide here for a lot more CAN information: https://github.com/Esoterical/voron_canbus
Original file line number	Diff line number	Diff line change
Expand Up		@@ -15,3 +15,5 @@
		4. If you run homing on Z or QGL and you are getting lots of restarts or excessive runs. Make sure you are using N52 magnets, and check that your umbilicals are properly support and the right length. If these 3 things aren't checked it will affect the tap precision.

		5. A lot of people are asking which toolhead/extruder is recommended. The answer is whatever you want. The changer and tools are completely separate. That being said, using something that is already a tested combination for Stealth Burner or Dragon Burner is going to be the easiest.

		6. CAN setup. You are definitely going to want to use CAN to connect your toolheads. Its only 4 wires and much lighter. You don't need anything fancy to split out the signal. Simple WAGO connectors work just fine. Of course, there are options for boards that will split the signal as well if you want something that looks a little more professional. Run wires up to the umbilical from your controller and power supply, then use WAGO's there to split the signal. See the guide here for a lot more CAN information: https://github.com/Esoterical/voron_canbus