A command line interface for HP 1820 J9979A switch.
HP 1820 J9979A only provides web management interface. This is awkward for network administrators familiar with Cisco IOS interface. Therefore, this project is the solution to encapsulate the two different management layer.
$ ./sshhp 192.168.1.1
Cannot connect https://192.168.1.1 : [Errno 111] Connection refused
HTTPS failed. Try HTTP...
*****************************************
*Warning: Connect through HTTP protocal.*
*****************************************
Password:
Type exit/forceexit to quit, help for help.
#setnetwork
management vlan id? (empty = 1)
dhcp or static?static
(if dhcp, left empty below) IP: 192.168.1.1
subnet mask: 255.255.255.0
gateway address:
#setinfo
Switch Name: new-switch
Location: here
Contact: bookgin
new-switch#showint
Interface Admin Mode Physical Type Port Status Physical Mode Link Speed MTU
1 Enabled Normal Link Up Auto 100 Mbps Full Duplex1518
2 Enabled Normal Link Down Auto 1518
3 Enabled Normal Link Down Auto 1518
4 Enabled Normal Link Down Auto 1518
5 Enabled Normal Link Down Auto 1518
6 Enabled Normal Link Down Auto 1518
7 Enabled Normal Link Down Auto 1518
8 Disabled Normal Link Down Auto 1518
TRK1 Disabled Normal Link Down Trunk 1518
TRK2 Enabled Normal Link Down Trunk 1518
TRK3 Enabled Normal Link Down Trunk 1518
TRK4 Enabled Normal Link Down Trunk 1518
new-switch#
Logout.
Session closed.You may have to install BeautifulSoup4 first.
$ git clone https://github.com/BookGin/hp1820-cli.git
$ cd hp1820-cli/
$ ./sshhp [email protected]
- Python 3.5
- requests 2.11.1
- BeautifulSoup4 4.5.1
- Port channel
- Ping Test (Need to handle javascript)
- Reboot switch
- Prettify the information output
- Download current config file (Need to handle javascript)
- Compatible with Python 3.4.2 due to this issue
The MIT License
