ZWN-RSM2 dual relay not updating device2 status via switch

[floatiepen]

I bought a ENERWAVE Z-Wave Plus Dual Relay Module (Device ID
282-1542-273 (0x011a-0x0111-0x0606); ZWN-RSM2-PLUS - from Amazon) and set it up, and at first, it seemed everything was great. Each switch controls its device and they both popped up in zwavejs2mqtt and in turn in Home Assistant. I can toggle the devices on/off via Home Assistant and all seemed great.

The trouble is that when Device2 is turned on at the switch, the z-wave object doesn't update. Moving the Device1 switch does correctly update the z-wave status. Is this a fault with the module? Or is there something in zwavejs2mqtt that isn't handling the update correctly?

In my setup, the module is node 7. When I look at Control Panel -> node 7 -> Binary Switch, I see the two booleans for currentValue:
[7-37-1-currentValue] -> updates when changed via z-wave or the physical switch (the expected behavior)
[7-37-2-currentValue] -> only updates when I toggle the device via z-wave (does not update when switch is moved)

I'm very new to z-wave and zwavejs2mqtt, so I'm not sure what more info to look at/provide to troubleshoot. If I knew where to look for the device settings, I'd have a go to see if I could fix it. maybe it's just a configuration quirk that needs handling.

Any tips on where to start to troubleshoot this?

[robertsLando]

@AlCalzone

[AlCalzone]

Please make a zwave-js log, loglevel debug or silly and attach it here as a file.

[floatiepen]

Thanks for looking into this. Here is the log of the interview:
zwavejs_1 - re-interview.log

After that, I did another log of toggling the physical switch, and it only seems to mention endpoint 0. Also, How long is the delay before the events are written to the log file on disk? I think I cut some off (since I had toggled each switch twice, and I only see 4 events in the log).
zwavejs_1 - 1 then 2.log

[AlCalzone]

Ok looks like this is because of the associations. Can you add Node ID 1 to both group 2 and 3 and check if that is better?

[floatiepen]

That did it! Both lights now work and respond to the change at the switch.

[AlCalzone]

Thanks, I raised zwave-js/node-zwave-js#2280

[floatiepen]

You have been very helpful, thanks again. And than you for submitting that other issue, I hope it gets resolved and makes life easier for future users.

[ronytomen]

Submitted PR zwave-js/node-zwave-js#4046