Question about T6 Pro second stage cooling mode reported status #3723
-
I have 13 HVAC units, six of which have two stage compressors. All controlled by T6 thermostats over ZWave. I have configured the tstat for two stage operation, and I can see in the temperature data what looks like throttling of the second compressor when temps get close to the setpoint.
|
Beta Was this translation helpful? Give feedback.
Replies: 1 comment 2 replies
-
You should see a json with value 2 in the payload of the valueid 66-0-state od node 85. That would mean (based on the states above) that the state is on cooling @AlCalzone any clue? |
Beta Was this translation helpful? Give feedback.
These reports come from the device, so if it reports Cooling (2) instead of 2nd Stage Cooling (9), there's no way we can know. According to your description, I assume the report at 07:29:52.697 should have been a 9, not a 2.
So yes, firmware issue.