Replies: 1 comment 15 replies
-
|
@DripSweat hello, That's not what Boot and Shutdown hardware keyboard states do. Boot - is a simple double blink animation before device starts booting into windows. Everything after that is Awake state. |
Beta Was this translation helpful? Give feedback.
-
|
@DripSweat it should be OFF, unless your laptop has a habit to reset backlight brightens settings on reboot (similar to charge limit). Some models do ... |
Beta Was this translation helpful? Give feedback.
-
Apparently so. Resets... |
Beta Was this translation helpful? Give feedback.
-
|
On BIOS firmware or even keyboard firmware |
Beta Was this translation helpful? Give feedback.
-
|
ok. |
Beta Was this translation helpful? Give feedback.
-
|
It's too specific, you can't do that atm |
Beta Was this translation helpful? Give feedback.
-
Good day to all.
"If this topic has already been discussed - please let me know (I didn't find a solution here)"
i use 0.191 version
The essence of the problem or question is very simple.
Inside the program, when setting the settings "boot" and "shutdown", the keyboard does the following:
The question is - what needs to be done so that only the animation works, and the keyboard does not turn on in vain at the moment of loading the operating system.
Reworking the method of launching the program g-helper (set the launch for "all", and before the user logs into the system) somewhat improved the situation, but the keyboard still remains on until the moment of starting the program.
Additional question - can the program "OpenRGB" solve these problems and will there be conflicts with g-helper?
Beta Was this translation helpful? Give feedback.
All reactions