Skip to content

Hardware, Cleaning and Calibration functions

Jump to bottom
markosjal edited this page Feb 12, 2020 · 12 revisions

Cleaning and Calibration

Cleaning and calibration functions are available from the web GUI and available to any logged in user. You should have the original cleaning and calibration sheets provided with your scanner.

If your scanner is producing black areas around the scanned image this is likely for one of the following reasons:

  • Scanner is dirty and dirt is being detected as image.
  • Scanner Needs Calibration
  • Firmware version of scanner may be very old. Please read the scanner manual to understand the proper cleaning process.

Hardware

Please note that some older firmware versions may not support 600 DPI scanning.s400w command line scanner v1.0-20141122 by bastel

To check your firmware version load the scan page on Web GUI then click the "Status". You will see a result like: Info > s400w: openSocket(): connected to 192.168.18.33:23 Debug> s400w: sendCommand(20203030): 4 Debug> s400w: readResponse(10000) Debug> s400w: get_version(): IO0a.032 result: IO0a.032 s400w command line scanner v1.0-20141122 by bastel Info > s400w: openSocket(): connected to 192.168.18.33:23 Debug> s400w: sendCommand(50006000): 4 Debug> s400w: readResponse(10000) Debug> s400w: get_status(): nopaper result: nopaper

There is an included ZIP archive s400wScanners.zip that will explain more about firmware versions, hardware commands, etc.

Clone this wiki locally