Fseq file upload

[surajchauhan6631]

I want to use espixelstick to work in standalone mode and cycle through the fseq sequence. I want to upload a fseq file from vixen software in which there is no option of fpp connect. Can I upload files manually to the sd card ?

[MartinMueller2003]

With Vixen you use export to create your fseq files in uncompressed mode. Then you drag & drop the files onto the file download are in the file manager page of the PixelStick UI.

Create a playlist (definition is in the readme) and select the playlist in the file to play on the device configuration screen. That list will be played until you stop it.

[surajchauhan6631]

where i have to select esp1 in list of controllers

[surajchauhan6631]

and one more issue i am facing is that i am lost the output1 settings for dmx even after clicking the save changes button.

[MartinMueller2003]

ESP1 is a made up name. You have only one controller defined so you do not have an issue.

[surajchauhan6631]

and one more issue i am facing is that i am lost the output1 settings for dmx even after clicking the save changes button. so i have to change the setting again. why this issue is persisting.

[MartinMueller2003]

I have never seen such a thing. Can you send me a log of the output when this is happening?

[MartinMueller2003]

ESPixelStick V4 support up to 8 serial outputs. You would need to create a base card that has the GPIO to RS-485 conversion or you could use 8 ttl to rs485 conversion boards.

[surajchauhan6631]

Ok, so using a customize board I can receive 8 artnet universe and send one universe on each dmx output port of 8 ports

[MartinMueller2003]

or E1.31 or DDP or fseq file on a local SD.

[MartinMueller2003]

I have never seen such a thing. Can you send me a log of the output when this is happening?

[surajchauhan6631]

I want to create custom board for Espixelstick with 8 port pixel output with ethernet connectivity for Artnet or e1.31 data input. Can you guide me which esp32 pin should be connected to which pin of ethernet chip.

[surajchauhan6631]

??

[MartinMueller2003]

ALL ESP32 devices are required to use the same pins. You can see an example of an 8 port controller by looking at the QuinLed Octa hardware platform definitions.