Skip to content

Latest commit

 

History

History
75 lines (62 loc) · 2.52 KB

armbian.md

File metadata and controls

75 lines (62 loc) · 2.52 KB

Prequisites

  • Armbian
  • At least kernel 4.14 (Mainline is prefered)
  • The HM-MOD-RPI-PCB and the RPI-RF-MOD are only working on supported platforms

Installation

  1. Create full backup of your SD card

  2. Add the public key of the repository

    wget -q -O - https://apt.pivccu.de/piVCCU/public.key | sudo tee /usr/share/keyrings/pivccu.asc

  3. Add the package repository

    echo "deb [signed-by=/usr/share/keyrings/pivccu.asc] https://apt.pivccu.de/piVCCU stable main" | sudo tee /etc/apt/sources.list.d/pivccu.list
sudo apt update

    Instead of stable you can also use the testing tree, but be aware testing sometimes means not that stable.

  4. Install the matching kernel headers

    sudo apt install build-essential bison flex libssl-dev
sudo apt install `dpkg --get-selections | grep 'linux-image-' | grep '\sinstall' | sed -e 's/linux-image-\([a-z0-9-]\+\).*/linux-headers-\1/'`

  5. If you are using a HB-RF-ETH, install the neccessary support package

    sudo apt install hb-rf-eth

  6. Install the neccessary device tree patches (You can skip this step, if you do not use the HM-MOD-RPI-PCB or RPI-RF-MOD on GPIO header, for the HB-RF-USB(-2) and HB-RF-ETH this step is not neccessary)

    sudo apt install pivccu-devicetree-armbian

  7. Install the neccessary kernel modules

    sudo apt install pivccu-modules-dkms

  8. Add network bridge (if you are using wifi please refer to the debian documentation how to configure the network and the bridge)

    • Verify, that eth0 is the name of your primary network interface:

      sudo nmcli connection show --active

    • Update your config. (Replace eth0 if necessary)

      sudo apt install bridge-utils
sudo nmcli connection add ifname br0 type bridge con-name br0
sudo nmcli connection add type bridge-slave ifname eth0 master br0

    • You can use an static IP address, too:

      nmcli connection modify br0 ipv4.addresses "<address>/<prefix>" ipv4.gateway "<gateway>" ipv4.dns "<dns1>,<dns2>" ipv4.method "manual"

      Replace

      , , , , with your settings. ist the subnet prefix (e.g. 24 for netmask 255.255.255.0)

  9. Reboot the system

    sudo reboot

  10. Install CCU container

    sudo apt install pivccu3

  11. Start using your new virtualized CCU, you can get the IP of the container using

sudo pivccu-info