Firmware Configurations for Voron 3D printers, separated by firmware. Remember to update this README when uploading new firmware configurations!
Configurations for legacy printers can be found here. If one of your configurations applies to a current generation Voron printer, contact the admins in Discord to have your mod moved to this folder.
Update the following table with the information about your mod:
- Your name
- A link to your sub-folder
- A short description of your firmware config
- The printer compatibility. Use
:heavy_check_mark:for ✔️,:x:for ❌ and:grey_question:for ❔
like so:
| Creator | [Config Title](link) | Description | :x: | :x: | :x: | :x: |
| Creator | Config title | Description | V0 | V1.8 | V2.4 | VSW |
|---|---|---|---|---|---|---|
| revnull | BTT Octopus Board Pins | Defines a set of [board_pins] aliases for use with the BTT Octopus controller |
❔ | ❔ | ✔️ | ❔ |
| Creator | Config title | Description | V0 | V1.8 | V2.4 | VSW |
|---|---|---|---|---|---|---|
| DorjeDorf | Duet 3 Config | RRF 3.3 example config | ❌ | ❌ | ✔️ | ❌ |
| fulg | Duet 2 Config | RRF 2.05 example config | ❌ | ❌ | ✔️ | ❌ |