generic-melzi.cfg

# This file contains common pin mappings for Melzi v2.0 boards. To use
# this config, the firmware should be compiled for the AVR
# atmega1284p.

# Note, a number of Melzi boards are shipped with a bootloader that
# requires the following command to flash the board:
#  avrdude -p atmega1284p -c arduino -b 57600 -P /dev/ttyUSB0 -U out/klipper.elf.hex
# If the above command does not work and "make flash" does not work
# then one may need to flash a bootloader to the board - see the
# Klipper docs/Bootloaders.md file for more information.

# See the example.cfg file for a description of available parameters.

[stepper_x]
step_pin: PD7
dir_pin: PC5
enable_pin: !PD6
step_distance: .0125
endstop_pin: ^!PC2
position_endstop: 0
position_max: 200
homing_speed: 50

[stepper_y]
step_pin: PC6
dir_pin: PC7
enable_pin: !PD6
step_distance: .0125
endstop_pin: ^!PC3
position_endstop: 0
position_max: 200
homing_speed: 50

[stepper_z]
step_pin: PB3
dir_pin: !PB2
enable_pin: !PA5
step_distance: .0025
endstop_pin: ^!PC4
position_endstop: 0.5
position_max: 200

[extruder]
step_pin: PB1
dir_pin: PB0
enable_pin: !PD6
step_distance: .002
nozzle_diameter: 0.400
filament_diameter: 1.750
heater_pin: PD5
sensor_type: EPCOS 100K B57560G104F
sensor_pin: PA7
control: pid
pid_Kp: 22.2
pid_Ki: 1.08
pid_Kd: 114
min_temp: 0
max_temp: 250

[heater_bed]
heater_pin: PD2
sensor_type: EPCOS 100K B57560G104F
sensor_pin: PA6
control: watermark
min_temp: 0
max_temp: 130

[fan]
pin: PB4

[mcu]
serial: /dev/ttyUSB0

[printer]
kinematics: cartesian
max_velocity: 300
max_accel: 3000
max_z_velocity: 5
max_z_accel: 100