-
|
Hi all, first of all this may not be necessary and may just be for my own learning. I was going to submit a PR for the V1 board to correct the motion sensor pins, however when it comes to the generation of the Gerber files I can see that there's a bit of a difference between my own generation and that in the repository already. The following are the differences I'm seeing and so I expect I'm not selecting the right options as I'm using defaults and have never done this before!
Apologies if this type of discussion is not the correct format, willing to move it to wherever appropriate. Thanks in advance! |
Beta Was this translation helpful? Give feedback.
Replies: 1 comment 1 reply
-
|
Hi @cptbucky, sorry for the delay and thank you for your afford. I would recommend to not to do anything but ignoring the V1. Just buy a V2 board :) But to answer your points... You have to generate the position file separately. I will have this in mind for the final release. |
Beta Was this translation helpful? Give feedback.
-
|
This is amazing, thank you @Schluggi |
Beta Was this translation helpful? Give feedback.
Hi @cptbucky,
sorry for the delay and thank you for your afford. I would recommend to not to do anything but ignoring the V1. Just buy a V2 board :)
But to answer your points...
You can check a box to merge both drill files together. This was default I think. If you have any reasons to separate these files I would change this for the next release.
You have to generate the position file separately. I will have this in mind for the final release.