You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
I was using ZHA with Sonoff USB Coordinator and decided to buy a SLZB-06 and switch to Zigbee2Mqtt. I deleted all devices of the sonoff and readded them to Z2M with no problem. The only device that shows under MQTT devices is the bridge and an incomplete device until the friendly name is changed, then the device disappears. Using MQTT Explorer, I verified the data written by Z2M is getting entered. The switches are missing control and the sensors are missing contact information. After the friendly name change, the entries under homeassistant disappear. Switch change or opening change is only written under zigbee2mqtt.
HA MQTT setup:
Broker
192.168.1.101
Port
1883
Username
Password
Client ID (leave empty to randomly generated one)
homeassistant
The time between sending keep alive messages
60
sec
Use a client certificate
Broker certificate validation
Off
Ignore broker certificate validation
Option to ignore validation of your MQTT broker's certificate.
MQTT protocol
3.1.1
MQTT transport
TCP
Enable discovery - On
Discovery prefix
homeassistant
Enable birth message - On
Birth message topic
homeassistant/status
Birth message payload
online
Birth message QoS
0
Birth message retain - Off
Enable will message - On
Will message topic
homeassistant/status
Will message payload
offline
Will message QoS
0
Will message retain - Off
reacted with thumbs up emoji reacted with thumbs down emoji reacted with laugh emoji reacted with hooray emoji reacted with confused emoji reacted with heart emoji reacted with rocket emoji reacted with eyes emoji
-
I was using ZHA with Sonoff USB Coordinator and decided to buy a SLZB-06 and switch to Zigbee2Mqtt. I deleted all devices of the sonoff and readded them to Z2M with no problem. The only device that shows under MQTT devices is the bridge and an incomplete device until the friendly name is changed, then the device disappears. Using MQTT Explorer, I verified the data written by Z2M is getting entered. The switches are missing control and the sensors are missing contact information. After the friendly name change, the entries under homeassistant disappear. Switch change or opening change is only written under zigbee2mqtt.
HA MQTT setup:
My Z2M config file:
Z2M log adding device
Z2M log opening change:
Beta Was this translation helpful? Give feedback.
All reactions