Warning
The hotend mounts are only compatible with thin PCB board sequins.
Known compatible sources:
RGBW: LAB4450 (EU)
RGBW: Replimat[labs] (EU)
RGBW: JB3D.uk (UK)
RGB: FYSETC (Ali Express)
Important
Wiring as shown will result in the LED order being the same as for the popular StealthBurner LED harness.
This should enable the use of popular LED control macros without complex modifications.
| Notes | Image |
|---|---|
| Required Tools | Wire cutters Wire strippers Soldering equipment Helping hands Crimping tools to suit your connection type |
| Get all the bits together (BoM) (11x) Lengths of 26 or 28AWG electrical wire: - (3x) ~200mm +/-/D with one end stripped and tinned - (4x) ~35mm +/-with one end stripped and tinned (+/-)- (3x) 70mm +/-/D stripped and tinned at both ends- (1x) ~135mm D stripped and tinned at both ends(1x) Neopixel LED PCB (2x) Sequin LED PCB (0.8mm thick PCB board) JST XH (or similar) connector and pins to suit your printer + = 5V+ wire - = Ground wireD = Data/Signal wire Lengths given are for a harness that works with either UHF or standard length toolheads |
 |
| Follow the wiring diagram above. The completed harness should look similar to the photos shown. Completed Harness |
 |
Neopixel Status LED |
 |
Sequin #1 Part Lighting |
 |
Sequin #2 Part Ligting |
 |
| Powered up! |  |