Fibaro Motion Sensor Device handler

This is my attempt to improve the existing device-handler by adding ALL available zwave paramaters from the application.

How it looks

Main screen

Settings part:

Pending state:

As you may know zwave battery powered devices are sleepy guys. They wake up every 2 hours (in this case) and you can send them commands during 15s.

Until the device is fully synchronized, the tile synced will show pending with a yellow background.

From there, you have two solutions:

Wait for the synchronization to converge (this could require several wake up from the device)
Force the synchronization by pushing the B-Button on the device and press on pending tile in the second after.

If you look at the live logging from the IDE you will see actions been done.

I have no luminance nor temperature reports
- You should wait for the next wake up or force the configuration by pressing B-Button and press Synced|Pending tile.
Vibration is always on
- This is the default behavior for tampering alerts, you should change the paramter 24 to value 4 vibration. This will report the vibration level.

Current values are not shown once set on iOS. ~~This is a smartthings issue and should be resolved soon.~~ FIXED